Sumitomo (SHI) Demag Prospekt Packaging englisch Seite 4

Hinweis: Dies ist eine maschinenlesbare No-Flash Ansicht.
Klicken Sie hier um zur Online-Version zu gelangen.

Inhalt

Which machine suits which application Both Systec SP as well as El Exis SP clearly exceed the valid industry standard with their high injection dynamics and short injection times Systec SP has proved itself in all applications where cycle times of 7 to 12 seconds and fl owpath wall section ratios of up to 350 are required El Exis SP convinces with its extremely high dynamics with rapid cycle times of less than 6 seconds and mould fi lling times of less than 100 ms Systec SP El Exis SP Industry standard Standard machine with hydraulic accumulators Caps In the production of standardised closure systems highest mould speeds must be realised alongside a short stroke and optimum dosing capacity El Exis SP meets these requirements and has a record of long term reliable and safe operation with cycles far below 2 5 seconds A highly dynamic ejector which can be precisely adjusted using activeAdjust demoulds caps at any temperature Thin walled packaging In the production of thin walled packaging such as yoghurt cups with or without in mould labelling El Exis SP shows all its advantages the particularly high injection dynamics and axle speed will help you realise any required fi lling time with low cycle times Dry cycle times 160 210 280 350 420 t Clamping force Cycle times sec0 1 0 2 0 Acceleration 200 600 400 800 a 32 m s2 a 16 m s2 a 5 m s2 1 000 mm s Injection dynamics Injection time ms 0 100 200 0 200 400 600 800 1 000 mm s Injection speed Cycle times 42 6 8 10 12 sec L T fl owpath wall section ratio El Exis SP L T 350 Systec SP L T 350